tz3den

Hey ppls, so i was thinking if i should transfer my custom fpv kwad to this ACK75 frame because my old frame is made for holding 2s and the props kept on hitting the prop guards so i had to trim it, plus i can take of the guard and it will become an open-pusher 75mm? My build was originally a Matrix V2 Aio fc, 4 Happymodel se0802 19000kv motors, C03 camera, GF 1614 props with Happymodel Mobula 7 v3 frame but one of the motor cables came loose from the motor( if you know happymodel motors, is not like betafpv ones, it doesn't have a board and it is just direct solder from copper wire to motor wire) so i soldered on the old motor wires from the happymodel ones on to my Betafpv 0802se 23000kv motor and some how, it acted like the old 19000kv motor? It flies normally too! Before that, in the motors tab i set the throttle limit to 85%. Should i do the transfer to this ACK75 frame? Btw is pusher better for freestyle? I dont see much ppl use pusher for freestyle, so is it bad? Is mostly for cinematic right?

This is my quad, Happymodel 19000kv brushless motor , Betafpv matrix v2 5in1 board with mob 7 frame. When I haven’t flashed the Betafpv air 75 firmware(like for that drone), it worked like this, if you are using the throttle under 40% it will fly like normal but if you push the throtttle more that 40% it will take over and do flyaway and say runaway at goggles. They told me to flash reset firmware for my board but I don’t k je cuz I don’t have impulserc_driver fixer. I have no idea what happened. So after that , I asked ai what happened to my drone and I explained it to him. He told me to to go to pid tune and go to filter to do that less filter or more filter thingy? I did it but I was worse. The drone would not even lift off. Once I arm it and throttle up slowly, it will stall and cut the motors power and spin to the left. Come on guys, please help me, I really want to get back in the air. All of my screws are tighten really good already. It sometimes go to the left and sometimes go to the right. The motor directions and props directions are correct too.

I built my first custom drone without soldering which is all plugs. Matrix v2 board, Happymodel se0802 19000kv, Happymodel mob 7 v3 frame with C03 cam. After assembly, done tuning in betaflight and bind phrase. When I tried flying it, it just lift off and if im under 40% throttle nothing happens but when it’s over 40% it shoots up by itself and take over without listening to my stick inputs. I watched some videos and they said that it was because of unfiltered, filtered loose screw that made vibrations? My kwad had no problems like that. Any ideas?

Hey guys, i decided to build my own drone that was solder free, the parts are Betafpv matrix v2, Happymodel mob 7 v3 frame , happymodel se0802 19000kv brushless motor and the C03 cam. Everything fits together and binded with my Radiomaster T8L perfectly. But after i arm the drone and lift a little bit of throttle( about 15-20%) it just shot up like a rocket and hit my celling and fell down. That same thing happened to my old Air 75v1 after soldering the motor wires back and factory reseting it. In the goggles it said "RUNAWAY". I have no idea what that means but AI told me that it was the motor sending out tiny vibrations to the board and the board just stall the motors? Please help man, I have spend a lot in this hobby and i do not want my parents to regret it. Help me guys. I don't know if it is the TX problem or the kwad itself. Pls help ppls, any help is appreciated. :(😟